TUTORIAL || How to Make a Simple Network Simulation Using Cisco Packet Tracer Application

in #utopian-io • 7 years ago (edited)

2.jpg

1.Open the cisco packet tracer application
image.png

2.Simple Network Installation Preparation in this example is to use two workstations and 1 switch. Each node is connected to the cable so it looks in accordance with Figure 3:
----1.Select the icon of the PC that sits in the left corner and then put on display
image.png
image.png

----2.Place the 2 pieces on the PC display
image.png

----3.Next select switch and put on display
image.png

----4.Slanjutnya the process of wiring to connect 2 PC, select the straight cable, create an image such as this, when the wires yet is green then the PC yet connect
image.png

3.And then do the configuration IP address host PC0 by means of double-click image PC0, then click the tab of the Desktop and choose menu section the IP Configuration so that the display is visible on the picture below This
image.png
image.png

4.Add the IP Address 192.168.123.1 and Subnetmask will come out automatically
image.png

5.Do the same on the workstation configuration is as follows: each PC with a different ip address
image.png

6.PING
To test the connection between the two nodes using the "ping" utility. To start the ping from PC0 PC1 headed, double-click the PC0 making it appear properties window for PC0, then select the tab of the Desktop, then select the menu Command Prompt so that it appears look like Figure 5 below.

image.png
image.png

7.Do a "ping" by way of typing: ping [ip_address_target] to do ping towards PC1 which has IP address 192.168.123.2 is by way of type in: ping 192.168.123.2
If the configuration you do is correct then the produced output like this:
image.png
image.png

CONCLUSION
From the results of experiments conducted, it can be concluded that:

  1. The new PC0 and PC1 workstations can be connected if both workstation IP addresses have been well configured and correct.
  2. To test connectivity between nodes can use the "ping" command.
    Results ping command output there are various kinds.
    Namely: Reply, Request Timed Out, andDestination Host Unreachable.

Download file :
Simple Networking Simulation


Posted on Utopian.io - Rewarding Open Source Contributors

#tutorial #cisco #network #networking
7 years ago in #utopian-io by
$0.04
6 votes
Reply 2
Sort:  
  • Trending
    • [-]
     7 years ago  

    Your contribution cannot be approved because it does not refer to or relate to an open-source repository. See here for a definition of "open-source."

    You can contact us on Discord.
    [utopian-moderator]

    $2.60
    • Past Payouts $2.60
    • - Author $2.27
    • - Curators $0.33
    1 vote
    Reply
    [-]
     7 years ago  

    Hey @deathwing, I just gave you a tip for your hard work on moderation. Upvote this comment to support the utopian moderators and increase your future rewards!

    $0.00
      Reply