Spinner with soda lids

Hello friends, today I want to show you a spinner that I made with my cousin Aaron, it was a bit difficult but with my uncle's help we finished it.

Materials:

• 6 soda caps
• 3 small coins
• 1 ink charge from a pen
• 2 pieces of wire
• 1 exact
• 1 silicone gun.

Take a lid to open a small hole in the middle with a hot wire.

We cut 2 soda caps and cut it in half

Once you have this, a part of the ink charge is cut off from the pen and placed in the center of the first cap pierced with silicone. Once the ink charge is stuck, take the two caps by placing silicone to stick the cable. L shape

Once it is stuck, it is inserted inside the ink load of the pen, remaining attached to the perforated cover on both sides. Silicone is then placed on the sides of the perforated lid to stick the remaining 3 caps

Once stuck silicone is placed in the center of each to introduce a coin to each lid, this in order to give weight to turn well our SPINNER.

I hope everyone likes it very much