Computer Tablet Handles

I like to have my computer Tablet on my lap while watching TV from my easy chair by the fireplace on a cold winter’s day. I find news programs, etc., more interesting if simultaneously researched on the Internet. But I have a problem with my Tablet ... the dang thing is so thin and slippery that it’s awkward to hang on to. So ... I made a set of Old Man’s Handles for it. Problem solved!

Step 1: Fabricate the Handles

The handles are made from 1½’ square hardwood scraps that I happened to have, but just about any wood approximately that size would do. First I milled a groove the same length as the width of my Tablet along one side of each handle blank with a ½” diameter round nose router bit. The groove is approximately ¼” deep, just enough to secure the Table in place.

Next I drilled two ½” diameter holes approximately 1” deep on the same side of each handle blank near each end. I used a forstner bit to make neat clean holes with flat bottoms.

Step 2: Dowel Assembly

I next placed a handle at each end of the Tablet in order to estimate the length of doweling needed and cut two pieces of ½” diameter wood doweling slightly longer than required. On trial-assembling the handles and dowels and laying the Tablet in place I determined the amount that the dowels had to be shortened to fit the Tablet snuggly.

After trimming the dowels to their proper length I fit one in each hole of one of the handles and secured them in place with #6 x ¾” flat head wood screws.

Step 3: Final Assembly

Finally I assembled the handles and dowels around the Tablet, inserted the dowels into the holes in the second handle and secured them in place with wood screws.