The method of engraving Moroccan henna

The Moroccan henna engraving

The beauty of Moroccan girls is of great importance, as they are always interested in appearing in the most beautiful and beautiful form. We consider them to be concerned with their hair and skin. Henna engraved on the body is one of the aesthetic secrets of Moroccan girls, using many different methods and methods. On how henna is engraved in the Moroccan way.

The method of engraving Moroccan henna

The inscription using the straw is an injection but does not contain a needle inside. This method can be used by following the following steps :

Smoothing the henna powder, by sifting it using a piece of gauze.

Put a few drops of alfalfa oil and lukewarm water on the henna, and mix well to get a soft paste.

Leave the henna paste aside for 2 hours until fermented before starting to use.

Place the henna inside the straw or syringe, using a teaspoon.

Put two drops of millet oil or sour lemon on the hands or on the area to be engraved Henna, and painted well.

Start by drawing the henna on your hands with the preferred engraving, leaving it to dry completely before washing.

Fix henna on the body through a low fat vegetable oil or lemon juice.

The embossing using the special tube

is purchased from the market and is in the form of a package similar to the packs of creams, ointments or toothpaste, so that their mouth is a small and pierced cracker from the middle, where the pressure must be pressed until the henna comes out of them, Press firmly until you do not go out a large amount of henna, distorting inscriptions.

Note: This type of henna should be kept in the fridge until it is used in the next few times, where it can be spoiled.

The engraving using plastic gloves

Is a stamp and is equipped with a variety of inscriptions, where it is pasted to the place where it is engraved, then put the henna in the drawing drawings and packaged well, leaving it to dry completely before washing, and finally clean the glove, and paste it on the special paper Tags, which are fitted with adhesive to fix it.

Embossing using the funnel

It can be done at home using simple tools, and by following a series of easy steps: preparing a square plastic piece, 18 x 18 cm in length, which is like the pieces in the kitchen cabinets. Grab one of the corners of the plastic piece, and rotate it in a circular way to get a funnel shape. Paste the edges of the funnel well to install them. Fill the funnel with henna paste, and draw on the body as desired.