What should I use to help seal the vapor barrier? We are going to be putting the walls back up soon, like any day now. What did you use?
You are viewing a single comment's thread from:
What should I use to help seal the vapor barrier? We are going to be putting the walls back up soon, like any day now. What did you use?
Just staple a plastic sheet over the insulation. They have it at the lumberyard. They consider it overkill here, but it will help with heating and cooling, by stopping the air leaks. It is NOT critical, just helpful. They seal the plastic joints with Tuck tape (not Duck tape) designed to stick and stay. I have seen them use 6 mil plastic but any thickness would be better than none, and it mounts with staples.
IF you can't, it is not a killer problem. It probably saves 5% of your heat loss. I will have to use it, because I need to use styrofoam on what I am adding, and it doesn't seal as well as the fiberglass.
:DThanks Toby! I'll run it by our crew and get some. Perfect timing too because we are almost ready to put in the insulation.
Wonderful! They use it exclusively up North, because that 5% is a lot more important up there.
Stay Blessed!
:)