My 1st Successful Failure (ENG / ESP)

in Hive Motors3 years ago

My 1st Successful Failure.png

Hello hello my dear readers, here is your friend Yisus, today I am going to tell you about the time I successfully damaged my fan trying to fix it hehe I still have the fan, I call it "my victim" hahaha.

Hola hola mis queridos lectores, por aquí quien les escribí es su amigo Yisus, el día de hoy les voy a contar de la vez que exitosamente dañe mi ventilador por tratar de arreglarlo jeje aun hoy por hoy tengo el ventilador, lo llamo “mi victima” jajaja

IMG-20210411-WA0002.jpg

For those who were able to read my previous post will know that I have no knowledge in terms of mechanics but I have every intention of learning, what I am going to write happened a few years ago, in the house where I lived before you could not sleep without a fan because the mosquitoes were unbearable and if you tucked completely the heat suffocated you, That is to say, it was a martyrdom to sleep without a fan, one night I woke up at midnight because the fan had stopped suddenly but you could hear the engine running, by then I had seen my dad and my uncle do maintenance every time it sounded bad or if it had little air.

Para los que pudieron leer mi anterior post sabrán que no poseo conocimientos en cuanto a mecánica pero tengo toda la intención de aprender, los que les voy a escribir sucedió ya hace algunos años, en la casa donde vivía anteriormente no se podía dormir sin ventilador por que los mosquitos eran insoportables y si te arropabas completamente el calor te sofocaba, es decir, era un martirio dormir sin un ventilador, cierta noche me despierto como a la media noche porque el ventilador se había detenido de golpe pero se escuchaba el motor encendido, para aquel entonces había visto a mi papa y a mi tío hacerle mantenimiento cada vez que sonaba mal o si echaba poco aire.

Untitled design (1).png

Usually they always uncovered it, cleaned the blades and put grease on the motor, I tried to do the same thing they did, went to the tank and got a slotted screwdriver, a rag to clean the blades and grease for the motor, it was very hot and the mosquitoes were buzzing in my ear, it was really annoying but I was encouraged that I could fix it this time.

Por lo general, siempre lo destapaban, limpiaban las aspas y le echaban grasa al motor, trate de realizar lo mismo que hicieron ellos, fue al depósito y busque un destornillador de estrías, un trapo para limpiar las aspas y la grasa para el motor, hacía mucho calor y los mosquitos zumbaban en mi oído era realmente molesta la situación pero estaba animado de poder yo arreglarlo esta vez.


IMG-20210411-WA0000.jpg

I started first removing the grid that protects the blades, I remove the blades and clean them with the rag (if they were dirty) after that I remove the cover that covers the motor, it is a 3 speed fan motor, I remove the part where the grease goes, but here is my main mistake and it was that I put too much grease to the motor being over-greased, at the time I did not know that was bad, so after that I covered it again and put everything in place, at the time it started perfectly, I was happy because I could do it myself, but after 30 minutes it stopped suddenly and started to run. It stopped suddenly and started to smell burnt, I was scared because I said nothing, I already damaged it hahaha, it was like that the over-greasing made the internal temperature of the motor to rise and started to lose power, but not only that but the excess of grease entered the motor winding.

Inicie primero quitando la rejilla que protege a las aspas, quito las aspas y las limpio con el trapo (si que estaban sucias) luego de eso quito la tapa que cubre al motor, es un motor de ventilador de 3 velocidades, quito la parte donde va la grasa, pero aquí está mi principal error y fue que le coloque mucha grasa al motor quedando sobre-engrasado, al momento no sabía eso era malo, así que después de eso lo volví a tapar y puse todo en su lugar, al momento encendió perfectamente, me sentí contento por que pude hacerlo yo mismo, pero al cabo de 30 min. Se detuvo de golpe y empezó a oler a quemado, me asuste porque dije nada, ya lo dañe jajaja, fue así el sobre-engrasado hizo que la temperatura interna del motor se elevara y empezara a perder potencia, pero no solo eso sino que el exceso de grasa entro en el embobinado del motor.

Untitled design (1).png

That night I had no choice but to end up sleeping without a fan, the next day even with the fear of scolding I told my dad what had happened, after an obvious scolding I called my uncle so that he could repair it since he is dedicated to repair fans, appliances and other things, a week later he returned it like new, even today "my victim" is still with us at home hehehe.

Esa noche no me quedo de otra que terminar durmiendo sin ventilador, al día siguiente aun con el temor del regaño le dije a mi papa lo que había sucedido, después de un obvio regaño llamo a mi tío para que él lo reparara ya que se dedica a reparar ventiladores, electrodomésticos y demás cosas, a la semana lo devolvió como nuevo, aun hoy por hoy “mi victima” sigue con nosotros en casa jeje

And well that's how I successfully damaged the fan, next week my bro-in-law is going to mount the box to my dad's car, I'm going to go to start learning wish me luck, I hope you liked my little memory, criticisms and suggestions please leave it in the comments, who wrote for you was your friend Yisus.

Y bueno así fue como exitosamente dañe al ventilador, la semana que viene mi cuñado le va a montar la caja al carro de mi papa, voy a ir para empezar aprender deséenme suerte, espero les haya gustado mi pequeño recuerdo, críticas y sugerencias por favor dejarlo en los comentarios, quien escribió para ustedes fue su amigo Yisus.

Thanks for reading, comment, vote and subscribe..png


The images were created by me in canvas / The translated text was thanks to DeelP

Las imagenes fueron creadas por mi en canvas / El texto traducido fue gracias a DeelP

Canva
DeelP

Sort:  

Jajajaja, que final. Tranquilo, @josuemonterola también ha dañado ventiladores, solo que ha seguido buscando soluciones.

 3 years ago  

Hola, bueno he tenido varias experiencias con ventiladores, claro, no los he sobre engrasado, pero se me han caído las bobinas y se parten los cables de cobre que traen y luego es difícil poder arreglarlo. Me ha ocurrido dos veces. Entiendo por lo que pasaste esa noche.

Y bueno,me imagino que le echaste un pote de grasa completo jeje ya que para causar todo ese daño. Te deseo suerte con la caja del carro de tu papá y ojalá no le hagas lo mismo (es broma).