Get ready! #zencash Super Nodes go into beta testing on July 10. Set up your #SuperNodes today! More info & instructions here ▶️ https://goo.gl/LBLw2g
The ZenCash Super Node tracking servers will be made public on July 10th.
Super Nodes may be set up to test and ensure they are working correctly during the ramp up period. It would be helpful to have as many Super Nodes connected as soon as possible to put a load on the new servers and infrastructure.
During the ramp up period the stake amount will be set at 3 Zen and it will be raised to the correct amount of 500 Zen on July 18th.
The securenodetracker which runs on a node has been updated to work with both Secure and Super Nodes. The new version is 0.3.0 and a release candidate (rc1) is in testing. It has been renamed to ‘nodetracker’. There is no need to update Secure Nodes at this time unless they are being migrated to a Super Node
General information is below. Please follow the links in each section for complete instructions.
If you are setting up a new Super Node
When the Super Node tracking servers are ready on July 10th, a Super Node can be created and tested to ensure it passed challenges.
Set up the VPS following the requirements which are greater than a Secure Node
The node must be set up using the new 0.3.x tracker.
The tracker prompts for the type of node during setup
Only 3 Zen is needed in the stake address until the 18th.
The stake address must be different than any stake address used by a secure node. They will be cross checked.
A small amount of Zen is needed in the node’s private addresses for challenges
When the stake is increased to 500 Zen, an Exception will be created and an email sent
Super Node Installation Guide (Link available soon)
If you are migrating a Secure Node
It’s likely you will want to wait until the last moment to migrate a Secure Node to a Super Node. The following general steps are suggested
Update the node to the physical requirements for a Super Node
When 0.3.0 is released, update your Secure Node and during setup enter ‘secure’
The new nodetracker keeps your configuration for each type of node
When you are ready to switch to Super Node, rerun the node setup and enter ‘super’ using the new stake address
Restarting the tracker will connect to the Super Node tracking servers
Once configured like this the node can switch between Secure and Super node types.
Migration Guide (Link available soon)
If you would like to test now
The Testnet tracking servers can be used to test Super Nodes even though they are set for Secure Nodes. Super Nodes use the exact same code as Secure Nodes and are just configured differently and require a different stake amount.
Set up a node (or upgrade your current testnet node) with 0.3.x
Set the zend.conf with ‘testnet=1’
The nodetracker setup process will detect the node is running on testnet
Have 42 Zen in the testnet stake address. Ask in the Discord #securenodes or #testnet-config channel for some testnet zen (znt)
SUPER NODE REQUIREMENTS
At least 500 ZEN in a t-address for staking
Four CPU cores minimum
8GB of RAM or more
100GB of storage or more
Zend: Both IPv4 and IPv6
Tracker: either IPv4 or IPv6 similar to Secure Nodes
96% node uptime per earning period
Maximum Challenge time of 150 seconds (may be adjusted)
Valid, non-expired TLS certificate
JOIN THE CONVERSATION WITH OTHER ZENCASH NODE OPERATORS ON DISCORD
keep it up
Hi! I am a robot. I just upvoted you! I found similar content that readers might be interested in:
https://blog.zencash.com/zencash-super-node-beta/